Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 190
FMI: 9
Description: Engine Speed Signal Not Available Via Controller Area Network (CAN)
Troubleshooting:
POSSIBLE CAUSES:
Aftertreatment Control Module (ACM), Motor Control Module (MCM), or Common Powertrain
Controller (CPC) needs reprogramming.
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)MCM
PID: N/A
SPN: 190
FMI: 9
Description: Engine Speed Signal Not Available Via Controller Area Network (CAN)
Troubleshooting:
POSSIBLE CAUSES:
Aftertreatment Control Module (ACM), Motor Control Module (MCM), or Common Powertrain
Controller (CPC) needs reprogramming.
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 190
FMI: 14
Description: Engine Overspeed While Driving
Troubleshooting:
POSSIBLE CAUSES:
1. Service brakes
2. Engine speed
Page
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 190
FMI: 15
Description: Engine Over Speed Pre-Warning
Troubleshooting:
DESCRIPTION:
This fault code sets when the engine speed is above 2300 rpm.
MONITORED PARAMETER:
Engine speed
TYPICAL ENABLING CONDITIONS:
Engine speed greater than 2300 rpm.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCEY:
Continuous when enabling conditions met.
TYPCIAL DURATION:
Two seconds
DASH LAMPS:
None
ENGINE REACTION:
Engine brakes are activated.
VERIFICATION:
Start and run the engine.
POSSIBLE CAUSES:
1. Service brakes
2. Engine speed
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 190
FMI: 16
Description: Engine Overspeed While Stationary
Troubleshooting:
POSSIBLE CAUSES:
1. Service brakes
2. Engine speed
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 191
FMI: 9
Description: ETC1 Message is Missing
Troubleshooting:
DESCRIPTION:
Transmission message is missing.
MONITORED PARAMETER:
CAN communication
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCEY:
Always enabled
TYPCIAL DURATION:
Two seconds
DASH LAMPS:
MIL
VERIFICATION:
Engine idle (one minute).
NOTE: Fault will set during Eaton transmission module reprogramming. If fault occurs while
programming, clear code and release vehicle.
POSSIBLE CAUSES:
1. Faulty Controller Area Network (CAN) line.
2. CPC needs reprogramming.
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 191
FMI: 13
Description: Transmission Output Speed Shaft Signal is Missing
Troubleshooting:
DESCRIPTION:
Transmission output shaft speed signal is missing.
MONITORED PARAMETER:
CAN communication
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCEY:
Always enabled
TYPCIAL DURATION:
Two seconds
DASH LAMPS:
MIL
VERIFICATION:
Engine idle: one minute.
POSSIBLE CAUSES:
1. Faulty Controller Area Network (CAN) line.
2. CPC needs reprogramming.