Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 1483
FMI: 2
Description: MCM Data Not Plausible
Troubleshooting:
POSSIBLE CAUSES:
1. Battery voltage.
2. Faulty MCM.
3. MCM needs reprogramming.
Page
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 1483
FMI: 12
Description: CPC3 Detected the MCM is Not Broadcasting Information on the PTCAN
Troubleshooting:
NOTE: This fault indicates the CPC3 detected the MCM is not broadcasting information on the
PTCAN. Note that TCM SPN 521224 FMI 14 and ACM SPN 1231 FMI 9 may also be present
when this fault is active.
POSSIBLE CAUSES:
1. Battery voltage.
2. Damaged pins.
3. Faulty PTCAN harness between the MCM and the PTCAN (Yellow) Star point connector
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 1484
FMI: 9
Description: Message Was Lost (Message Counter Error)
Troubleshooting:
DESCRIPTION:
This diagnostic is typically J1939 message.
MONITOR PARAMETER:
J1939 message
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCEY:
Always enabled
TYPCIAL DURATION:
Two seconds
DASH LAMPS:
CEL
ENGINE REACTION:
None
VERIFICATION:
Idle
POSSIBLE CAUSES:
1. Battery voltage.
2. Faulty Controller Area Network (CAN) line.
3. Common Powertrain Controller (CPC) needs proper configuration.
4. Faulty CPC.
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 1484
FMI: 13
Description: Message Was Lost (CRC Error)
Troubleshooting:
DESCRIPTION:
J1939 message was lost.
MONITORED PARAMETER:
J1939 message
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCEY:
Always enabled
TYPCIAL DURATION:
Two seconds
DASH LAMPS:
CEL
ENGINE REACTION:
None
VERIFICATION:
Idle
POSSIBLE CAUSES:
1. Battery voltage.
2. Faulty Controller Area Network (CAN) line.
3. Common Powertrain Controller (CPC) needs proper configuration.
4. Faulty CPC.
Make: Detroit
Engine: DD15 GHG17 (2017 & Newer)
PID: N/A
SPN: 1590
FMI: 9
Description: Adaptive Cruise Control Message Not Received
Troubleshooting:
DESCRIPTION:
Adaptive cruise control message not received.
MONITORED PARAMETER:
PGR043 adaptive cruise control enable.
TYPICAL ENABLING CONDITIONS:
1. Key on.
2. CPC online.
3. CAN network online.
4. Adaptive cruise control system equipped.
5. 10 seconds after the engine has been cranked.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCEY:
Continuous when enabling conditions met.
TYPCIAL DURATION:
Two seconds
DASH LAMPS:
None
ENGINE REACTION:
None
VERIFICATION:
Engine running for one minute.
POSSIBLE CAUSES:
1. Faulty Common Powertrain Controller (CPC).
2. Faulty wiring.